TM 10-3930-664-24 2-44.  ACCELERATOR ACTUATOR WITH PEDAL REPLACEMENT This task covers: Removal, Cleaning, Inspection, and Installation INITIAL SETUP: Tools and Test Equipment: Personnel Required: General Mechanics Tool Kit (1, App.  E) 2 Personnel Drain Pan (10, App.  E) Materials / Parts: Teflon Tape (35, App.  C) Brake Fluid (5, App.  C) A.  REMOVAL 1. DISCONNECT     HOSES     (1,     2)     AND     REMOVE ACCELERATOR ACTUATOR ASSEMBLY (3) FROM FLOOR PLATE. a. Place  drain  pan  beneath    accelerator  actuator assembly (3). b. Disconnect   hoses   (1,   2)   from   elbow   (7)   and actuator fitting.  Cap hose ends. NOTE Observe   pedal   (9)   and   note   which mounting hole is used before removing screw (10).  This will aid in reassembly. c. Remove screw (10) that secures rod end (11) to pedal (9).  Remove spacer (12). d. Remove accelerator actuator  assembly  (3)  from floor  plate  by  removing  screws  (4),  accelerator stop (5), and nuts (6). e. Remove    elbow    (7)  from    accelerator  actuator assembly (3). B.  CLEANING Clean   accelerator      actuator   assembly      in   accordance with paragraph 1-24. 2-141