 |
|||
|
|
|||
|
Page Title:
CLUTCH PACK HUB AND DRUM, PISTON AND DISC ASSEMBLY - continued |
|
||
| ||||||||||
|
|
 STEP 23. Turn the gear and watch the inner discs
to determine if they are engaged. When the gear
has completely entered the discs it should be
1/4 inch below the top of the end plate. Install
a thrust washer over the shaft with the lub-
brication grooves facing the gear.
Step 23. Plate 8043
STEP 24. Check the total clearance of each set
of discs by inserting a feeler-gauge between
any two discs. if a .050 inch feeler will not
enter between the discs the clearance is insuf-
ficient and one steel disc should be removed
from the outer end of that particular pack. if
a .120 feeler will enter, the clearance is too
great and a steel disc should be added to the
pack. Add or remove a steel disc as necessary
to maintain a minimum clearance of .050 inch or
a maximum of .120 inch at each pack.
Step 24. Plate 8045
5-80S
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals