Order this information in Print

Order this information on CD-ROM

Download in PDF Format

     

Click here to make tpub.com your Home Page

Page Title: Operation in Cold Weather
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Combat
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
USMC
   
Products
  Educational CD-ROM's
Printed Manuals
Downloadable Books
   

 

Back
Figure 2-15.  Preparing the Tarpaulin for Stowage
Up
TM-5-3805-274-10 Dump Truck Body M917 (NSN 3805-01-028-4389) Manual
Next
CHAPTER 3 MAINTENANCE INSTRUCTIONS

TM 5-3805-274-10 Section II.  OPERATION UNDER UNUSUAL CONDITIONS 2-9. Operation in Windy Weather. WARNING Do not attempt dumping   rations in high or gusty winds. In moderate winds, use  the  tarpaulin to keep material from blowing out of the dump bed. Be sure the tie-down straps are in place to prevent flapping (fig.  2-). 2-10. Operation in Rainy or Snowy Weather. CAUTON Do not leave r tarpaulin installed on the truck in conditions where snow w ill accumulate  the tarpaulin.   is   will   cause   the   tarpaulin   to   become   stiff   and   unmanageable,   and   could   dame tarpaulin. Use the tarpaulin to keep the loads dry.  Wet loads may stick, making dumping difficult. 2-11. Operation in Cold Weather. Cold weather presents special problems because cold oil and hydraulic components should not be operated  to  capacity until the system has been warmed up.  This can be accomplished by performing the following steps: a. Engage the PTO (TM 9-2320-273-10) while the engine is warming up.  Idle speed should not exceed 1100-1200 RPM. b. Clear all personnel from around the dump body. c. Squeeze the hydraulic control lever heed together (see fig.  2-5) and check operation of the body at low  engine RPM’s to verify reasonably normal operation.  Keep in mind that oil has not been circulated through the pilot valve and hoist cylinder. d. Lower the dump body, release the T-handle, and place the control lever in the N (neutral) position. 2-18

Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing