|
| |
Back
OPERATING BODY PROPS | Up
TM-5-3805-264-14P Truck Dump Heavy Body M917A1 and M917A1 W/MCS (Material Control System) Manual | Next
CHAPTER 3 OPERATOR MAINTENANCE |
TM 5-3805-264-14&P
Section IV.
OPERATION UNDER UNUSUAL CONDITIONS
Paragraph
Number
Paragraph Title
Page
Number
2-16.
Operation in Windy Weather . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-39
2-17.
Operation in Rainy or Snowy Weather. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-39
2-18.
Operation in Cold Weather. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-39
2-16.
OPERATION IN WINDY WEATHER.
DO NOT attempt to dump in high wind. High winds may disperse aggregate, caus-
ing injury to personnel or damage to equipment. High winds may also cause dump
truck to roll over when bed is raised. Failure to follow this warning could result in
death or injury to personnel or damage to equipment.
In moderate winds use cargo cover to keep material from blowing out of dump bed.
2-17.
OPERATION IN RAINY OR SNOWY WEATHER.
a.
In rainy or snowy weather use cargo cover to keep loads dry. Wet loads may stick, making dump-
ing difficult.
DO NOT leave cargo cover extended over an empty dump body. DO NOT attempt to
uncover load without first removing any snow or water that has accumulated on
cargo cover. Cargo cover may be damaged if this caution is not followed.
b.
Remove any accumulated snow or water from cargo cover before attempting to uncover load
2-18.
OPERATION IN COLD WEATHER.
Cold weather presents special problems because cold oil and hydraulic components should not be oper-
ated to capacity until the system has warmed up. This can be accomplished by performing the following steps:
a.
Engage PTO (TM 9-2320-363-10) while engine is warming up. Run engine at idle speed.
b.
Clear all personnel from around the dump body.
c.
Operate hydraulic control lever and check operation of dump body at low engine rpms to verify
normal operation (paragraph 2-10). Keep in mind that oil has not been circulated through the hydraulic cylinder.
d.
Lower dump body and place hydraulic control lever in N (Neutral) position (paragraph 2-10).
2-39/(2-40 Blank)
|
