TM 5-3805-254-20-2 GENERATOR AND REGULATOR - CONTINUED ACTION LOCATION ITEM REMARKS REMOVAL 1. Generator pulley (1) Two drivebelts (3) Take off (page 2-665). and crankshaft pulley (2) 2. Generator (4) Screw (5), lock- a. Using 1/2-inch open-end wrench, un- washer (6), and screw and take out. clamp (7) b. Get rid of lockwasher. 3. Rubber boot (12) Slide back and take off. 4. Nut (9), lockwasher a. Using 7/16-inch open-end wrench, un- (10), and wire screw and take off. connector (11) b. Get rid of lockwasher. 5. Push-on Pull off. connector (8) 6. Adjusting strap (13) Screw (14) and a. Using 314-inch box-end wrench, un- lockwasher (15) screw and take out. b. Get rid of lockwasher. 7. Mounting Screw (17), nut a. Using two 3/4-inch box-end wrenches, bracket (16) (18), and lock- unscrew and take out. washer (19) b. Get rid of lockwasher. CAUTION Use care when performing steps 8 and 9.  Damage to generator could occur. 8. Generator (4) Carefully take out. INSTALLATION 9. Generator (4) Carefully put in. 10. Mounting Screw (17), nut Screw in until snug using 314-inch box-end bracket (16) (18), and new lock- wrench. washer (19) 11. Adjusting strap (13) Screw (14) and new Screw in until snug using 3/4-inch box-end lockwasher (15) wrench. 2-668