|
| |
- DEPARTMENT OF THE ARMY
TECHNICAL MANUAL
- WARNING
- DIRECT SUPPORT AND GENERAL
SUPPORT MAINTENANCE MANUAL
- LIST OF ILLUSTRATIONS
- Section I. GENERAL
- Section II. DESCRIPTION AND
DATA
- Figure 1-1 Practical wiring
diagram
- Section I. REPAIR PARTS,
SPECIAL TOOLS AND EQUIPMENT
- Section III. GENERAL
MAINTENANCE
- General Maintenance
Instructions
- Seals.
- Figure 2-1. Boom removal
proceudres.
- Figure 2-2. Mast frame
removal procedures.
- Engine
- Figure 2-3. Engine and
transmission prepared for removal
- Engine - CONT
- Section I. BOOM.
- Figure 3-1. Boom topping
cylinder, explode view
- Room Extension Cylinder
- Figure 3-2. Boom extension
cylinder, exploded view.
- Boom
- Figure 3-3. Boom exploded
view.
- Section II. MAST ASSEMBLY
- Figure 3-4. Winch assembly,
exploded view.
- Figure 3-4. Winch assembly
exploded view.
- Figure 3-5. Stewing
cylinder, exploded view.
- Figure 3-6. Turntable and
slewing linkage, exploded view.
- Figure 3-7. Generator,
exploded view.
- Turntable and Slewing
Linkage
- Figure 3-8. Starter,
exploded view.
- Section IV. Cooling System
- Figure 3-9. Carburetor,
exploded view.
- Section V. Fuel System
- Figure 3-10. Governor,
exploded view.
- Section VI. Hydraulic System
- Figure 3-11. Hydraulic pump,
exploded view.
- Control Valve
- Figure 3-12. Control Valve,
exploded view
- Figure 3-13. Cushion valve
and pressure regulator, exploded view
- Figure 3-14. Steering
cylinder, exploded view.
- Steering Gear and Related
Parts
- Figure 3-15. Steering gear
and related parts, exploded view.
- Figure 3-16. Rear axle
spindle and related parts, exploded view
- Reassembly and Installation.
- Figure 3-17. Front wheel,
drive shaft, and brake drum removal.
- Figure 3-18 Service Brake,
exploded view.
- Figure 3-19. Master brake
cylinder, exploded view.
- Figure 3-20. Differential,
exploded View.
- Differential
- CHAPTER REPAIR OF
TRANSMISSION AND TORQUE CONVERTE
- Figure 4-1. Reversing
gearbox, exploded view.
- Transmission Oil Pan and
Regulator Valve
- Figure 4-2. Transmission oil
pan and regulator valve, exploded view.
- Figure 4-3. Vacuum control
valve removal.
- Figure 4-4. Transmission
rear servo adjuster and test port
- Figure 4-5. Control valve,
installed view
- Figure 4-6. Control valve,
exploded view.
- Figure 4-7. Front and rear
servos removal.
- Figure 4-8. Front and rear
servos, exploded view.
- Transmission Lever Linkage
- Figure 4-9. Transmission
lever linkage removal
- Figure 4-10. Transmission
lever linkage, exploded view.
- Figure 4-11. Transmission
assembly
- Figure 4-12 (1).
Transmission, exploded view.
- Figure 4-12 (1).
Transmission, exploded view.
- Figure 4-12 (2).
Transmission, exploded view.
- Reassembly.
- Figure 4-13. Torque
converter, exploded view.
- Section I. FLYWHEEL AND
HOUSING
- Figure 5-1. Flywheel,
removal and installation.
- Figure 5-2. Flywheel housing
exploded view.
- Figure 5-3. Timing gear
cover removal.
- Section III. PAN AND PUMP
- Section IV. VALVES AND
PISTONS
- Figure 5-7. Valves, guides,
and lifters removal.
- Figure 5-8. Valves, guides,
and lifters, exploded view.
- Pistons and Connecting Rods
- Figure 5-9. Piston and
connecting rod, exploded view.
- Section V. CRANKSHAFT AND
CAMSHAFT
- Figure 5-10. Crankshaft and
related parts, exploded view.
- Figure 5-11. Camshaft and
bearings, exploded view.
- Figure 5-12. Engine block.
exploded view.
- Cleaning, Inspection and
Repair.
- APPENDIX A REFERENCES
- INDEX
- DIRECT SUPPORT AND GENERAL
SUPPORT MAINTENANCE MANUAL
- CRANE, TRUNK; WAREHOUSE;
SLEWING BOOM- 1971
- By Order of the Secretary of
the Army:
- BLANK PAGE
- TM-10-3950-203-34
- By Order of the Secretary of
the Army:
- NOT DIGITIZED
- RECOMMENDED CHANGE TO
EQUIPMENT TECHNICAL PUBLICATION
|
|