|
| |
Back
2.1 GENERAL MAINTENANCE PROCEDURES | Up
TM-5-3895-373-34 Paving Machine Bituminous Material Crawler Mounted Diesel Engine Driven Manual | Next
SECTION II. TROUBLESHOOTING |
TM 5-3895-373-34
k.
Use only authorized replacement parts as
specified in maintenance tasks. Do not repair or replace
any part or component on a temporary basis. Refer to
TM 5-3895-37324P, Repair Parts and Special Tools List
(RPSTL) for correct replacement parts.
1.
Remove rust, corrosion, and coating oils
on components before repainting. Thoroughly clean
surfaces before repainting. Do not paint over seals or
gaskets. Do not allow paint overspray to enter air
intakes or hydraulic components. Do not paint over
bearings or lubricated parts. Refer to TM 43-0139 for
TACOM equipment painting requirements.
SECTION I. REPAIR PARTS; TOOLS; SPECIAL TOOLS;
TEST, MEASUREMENT AND DIAGNOSTIC EQUIPMENT (TMDE);
AND SUPPORT EQUIPMENT
Para
Page
Common Tools and Equipment...............................................................................................................
2.2
2-2
Repair Parts
............................................................................................................................
2.4
2-2
Special Tools and Equipment..................................................................................................................
2.3
2-2
2.2
COMMON TOOLS AND EQUIPMENT.
For authorized common tools and equipment, refer to the
Modified Table of Organization and Equipment (MTOE)
applicable to the CTA 5-970 or CTA 8-100, as applicable
to your unit. Refer to Appendix D for common tools used
in maintenance procedures.
2.3
SPECIAL TOOLS AND EQUIPMENT.
Special tools are listed in TM 5-3895-373-24P, Repair
Parts and Special Tools List (RPSTL) and in the
Maintenance Allocation Chart (MAC) (TM 5-3895-373-
20).
2.4
REPAIR PARTS.
Repair parts are listed and illustrated in TM 5-3895-373-
24P, Repair Parts and Special Tools List (RPSTL)
covering direct support/general support maintenance for
this equipment.
2-2
|
