TM 5-3895-373-20 1.7. OFFICIAL NOMENCLATURE. This     list     provides     a     cross-reference     between     the nomenclature used in the manual and the nomenclature specified   in   the   Repair   Parts   and   Special   Tools   List (RPSTL).  Nomenclature Cross- Reference List Manual Nomenclature Official Nomenclature Paving Machine 780T Bituminous Asphalt Paving Machine Screed Hydraulic Vibratory Extendable Screed, ES-80 (Diesel) Hopper Aggregate Feeder Hopper Wing Aggregate Feeder Auger Screw Conveyor Flashing Solid Rubber Sheet Dipstick Liquid Gauge Rod-cap Bendix Electric Engine Drive Coolant Temperature Thermostatic Switch Sensor Hydraulic Oil Thermostatic Switch Temperature Sensor Hemi Auger Flight Screw Conveyor Auger Quarter Auger Flight Screw Conveyor Auger Sound Foam Sound Control Batten Alternator Engine AC Generator Latch Pawl Fastener Fuel/Water Separator Fluid Filter Fuel Spray Wand Nozzle and Hose Assembly Assembly Pump Drive Gearbox Angle Drive Unit Speed Reduction Speed Gear Assembly Gearbox 1.8. USE OF METRIC UNITS. The equipment described herein contains metric components and requires metric common tools. Therefore,   metric   units   are   used   for   components   or systems  which  are  metrically  dimensioned,  and  no  U.S. standard unit is applicable.    In  all  other  situations,  U.S. standard units and metric units are both referenced. 1.9. PREPARATION FOR STORAGE OR SHIPMENT. Instructions are provided in Chapter 2. 1.10. LUBRICATION ORDER. For     lubrication     intervals     and     instructions,     refer     to Lubrication Order, LO 5-3895-373-12. SECTION II.   EQUIPMENT DESCRIPTION AND DATA Para Page Battery and Toolbox Storage Compartments ........................................................................................ 1.12.3 1-8 Characteristics, Capabilities, and Data ................................................................................................. 1.11 1-3 Engine Compartment ............................................................................................................................ 1.12.1 1-3 Equipment Data..................................................................................................................................... 1.13 1-14 Hopper Auger/Conveyor Systems......................................................................................................... 1.12.5 1-10 Hydraulic Cylinders................................................................................................................................ 1.12.6 1-11 Location and Description of Major Components ................................................................................... 1.12 1-3 Relay and Circuit Breaker Panel ........................................................................................................... 1.12.9 1-13 Screed Burner System .......................................................................................................................... 1.12.7 1-12 Screed Vibrators.................................................................................................................................... 1.12.8 1-13 Track Drive System ............................................................................................................................... 1.12.4 1-9 Valve Panel Compartment .................................................................................................................... 1.12.2 1-6 1-2