|
| |
Back
4. REMOVE ALTERNATOR | Up
TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual | Next
3. RECONNECT ALTERNATOR BELT ADJUSTING ARM |
TM 5-3895-373-20
7.2.
REPLACE ALTERNATOR - Continued.
B.
INSTALL - Continued.
2.
INSTALL ALTERNATOR.
a.
If removed, install sleeve spacer (26) into bottom
bracket. Insert spacer from direction shown in
illustration. Installed spacer should stick out a
little from outside edge of bracket. Use a
hammer if necessary.
b.
Install alternator (22), bushing blank (25), and
pivot bolt (19).
c.
Install washer (24), ground wire (23), and self-
locking hex nut (20). Do not tighten nut at this
time.
GO TO NEXT PAGE
7-8
|
