USA Display Flag

TM 5-3895-374-24-1 SECTION IV - PARAMETERS Note In order to change the parameters of the indicator you must be in the Calibration mode (flashing ’[’ the far left digit - see Calibration Section III). *In the following list of Parameters, the Factory Preset value will be indicated in ( ). Parameter No. Description 1. Reload Factory Values. Calibrates the scale with commonly values. When you have selected this function, press (1) [ENTER]. Note this will clear previous calibration. 2. Decimal Point Position. (0) 0, 1, 2, 3 or 4. Select to correspond graduation size. e.g. set to 1 for .5 grads, set to 0 for 10 KG grads. 3. Graduation Size. (2 LB/1 KG) Select one from this table: LB .0002, .0005, .0010, .002, .005, .010, .02, .05, .10, .2, .5, 1, 2. 5, 10, 20. 50, 100, 200. KG .0001, .0002, .0005, .001, .002, .005, .01, .02, .05, .1, .2, .5, 1, 2, 5, 10, 20, 50, 100. 4. Overweight. (15002 LB/6805 XG) Must be less than 5000 displayed graduations and greater than 1 graduation. 5. Motion Window. (4 LB/2 KG) Enter a weight to determine motion sensitivity. A typical value is 2 times graduation size. Note the motion window met automatically when the grad (Parameter 3) is changed. 6. Power On Units. (0 = LB) Selects the displayed units active when power is applied to the indicator. 1 selects KG; 0 selects LB. 7. Change Displayed Units. (LB) Allows you to calibrate in pounds 0 kilograms. Each time this parameter I selected. the displayed units will toggle. 8. USA Display Flag. (0) The USA display flag can be set to ’0’ o ’1’. Setting the flag to ’0’ gives the standard display. Setting the flag to ’ 1 causes the following display changes a) Dead Zeros - The active digit will always be displayed at zero, i.e. for a grad size of 10, the zero display will be ’00’. b) Dead Zeros behind decimal points - For grad sizes of .0010 LB .0005 KG, .010 LB/.005 KG, .1LB/.05 KG and 1.0 LB/.5 KG the extra dead zero shown in the LB mode will be blanked This is only effective fo decimal positions greater than ‘O’. The USA flag must be set to '1' for the indicator to be 'Legal for Trade" in the USA. 9. Power On Reset Warning. (1) The Power On Reset Flag allows designation os the power push to zero mode. If this flag is set to '0', the indicator will start with its push to zero register cleared and the weight display active. If this flag is met to '1', then the weight display will show 'rrrrrr' on power up until an initial push to zero occurs. To be legal for trade, this flag must be set to '1'. Page 3-66