TM 5-3895-374-24-1 GP470FA LOAD CELL WIRING GUIDE EXCITATION EXCITATION OUTPU T OUTPU T SHIELD (+) (-) (+) (-) Revere Green Black White Red Orange BLH Green Black White Red Yellow HBn Green Black White Red Bare Tedea Green Black Red White Bare Transdu cers Red Black Green White Orange Interfac e Red Black Green White Bare Genisco Red Black Green White Bare LeBow Red Black Green White Bare Ametek Red Black Green White Bare Sensortr onics Red Black Green White Bare Celesco Red Black Green White Bare Stra insert Red Black Green White Bare Pesage Promo tion Blue White Red Black Yellow USE THIS HANDY GUIDE TO HELP CROSS REFERENCE THE WIRING OF THE LOAD CELLS LISTED. Wiring of Printer, Data Comm, Remote Display Connector A cable  for serial communication between the DF200 and a printer, computer or remote display is connected to terminal block TB2 (see Fig 5). FIG.  5 - TB2 PRINTER/DATA COMM CONNECTOR BLCCK - DESXTOP TB2 terminals are as follows: +5V +5VDC (NOT USED FOR PRINTER/DATA COW TX TRANSMIT DATA (DATA OUT) RX RECEIVE DATA (DATA IN) GND GROUND (DATA GROOND) Note. See Appendix I Serial Output Port Setup for information on Baud Rate and Port operating mode setup. (page 3-60)