| |
Back
Chapter 8 Rules and Steel Tapes | Up
Tools And Their Uses - Hand tools and what they are used for | Next
Using Rules and Tapes Examples |
TM 9-243
TYPES AND USES
The rule or tape is used for measuring where accuracy is
not an extremely critical factor. They can be rigid or
flexible, come in various lengths, and can be made of
wood, metal, cloth, or fiberglass.
RULES
The rule is the most common of measuring tools. This
rule is usually 6 or 12 inches in length, although other
lengths are available. Steel rules may be flexible or
nonflexible, but the thinner the rule, the easier it is to
measure accurately because the division marks are
closer to the work.
A rule usually has four sets of graduations, one on each
edge of each side. The longest lines represent the inch
marks. On one edge each inch is divided into 8 equal
spaces so each space represents 1/8 in. The other edge
of this side is divided in sixteenths. The 1/4-in. and
1/2-in. marks are commonly made longer than the
smaller division marks to facilitate counting, but the
graduations are usually not numbered individually, as
they are sufficiently far apart to be counted without
difficulty. The opposite side is similarly divided into 32
and 64 spaces per inch, and it is common practice to
number every fourth division for easier reading.
There are many variations of the common rule. Some-
Steel tapes are made from 6 to about 300 feet in length..
times the graduations are on one side only, sometimes a
The shorter tapes are made with a curved, but rigid,
set of graduations is added across one end for measur-
ing in narrow spaces, and sometimes only the first inch
cross section flexible enough to be rolled up. Long, flat
is divided into 64ths, with the remaining inches divided
tapes need support over their full length to avoid sag-
into 32nds and 16ths. A metal or wood folding rule may
ging. Lack of support can cause reading errors. The
most common types of steel tapes have a hook at one
be used.
end to let one person take all the readings.
FOLDING RULES
These folding rules are usually from two to six feet long.
The folding rules cannot be relied on for extremely accu-
rate measurements because a certain amount of play
develops at the joints after continued use.
STEEL TAPES
8 - 2
|
