Types and Uses

TM 9-243 TYPES AND USES UNIVERSAL GEAR PULLER The universal gear puller is usually of yoke and screw construction with two jaws. The jaws have a capacity from 0 to 14 inches in diameter. The universal gear puller is used for pulling gears, pulleys, and wheels. GEAR AND BEARING PULLER The gear and bearing puller is used to pull gears, bear- ings, pinions, sheaves, pulleys, and wheels. It is a screw-type puller with two jaws. The grip tightens as pull is increased. The gear and bearing puller has a maximum spread of 5-1/2 inches. UNIVERSAL BEARING AND BUSHING PULLER The universal bearing and bushing puller has inter- changeable jaws. It provides a pulling capacity of up to 1-1/4 inches. The larger jaws are used for removing bronze or oilite bushings without crumbling them. The smaller jaws are used to pull clutch pilot bearings. ELECTRICAL UNIT BEARING PULLER The electrical unit bearing puller is used to pull bearings from shafts of electrical units. It is supplied with plates to fit a variety of unit constructions and to fit behind the particular shaft bearings to be pulled. BATTERY TERMINAL AND SMALL GEAR PULLER The battery terminal and small gear puller is a screw- type puller for use in close quarters. In addition to pulling battery terminals, it is used to pull small gears and bearings. STEERING GEAR ARM PULLER The steering gear arm puller is used for pulling steering gear arms. It also can be used for a wide variety of other pulling jobs. The clamp locks the puller on the arm, leaving both hands free for pulling. 41-2