| |
Back
Using a Tubing Bender | Up
Tools And Their Uses - Hand tools and what they are used for | Next
How to Choose and Use Them |
TM 9-243
USING AN ELECTRICAL CONDUIT HAND BENDER
1
Install handle (1) on bender (2). A section of
threaded pipe may be used as a handle.
2
Tip the bender forward and slide the section of
conduit (3) to be bent through the retaining hook (4).
3
Place mark where bend is to start opposite the
arrow on the front end of the bender.
CARE OF BENDERS
CAUTION
Do not jerk the handle, as this will create
internal cracks and ridges inside the con-
duit which will cut the wires.
4
Place one foot on the foot rest (5) and push down
with your foot while pulling back on the handle.
Apply steady pressure throughout the entire bend-
ing process.
5 When desired bend has been obtained, release the
pressure on the conduit by returning the handle to
an upright position and slide the conduit out of the
bender.
1.
Clean all grease and oil from gripping surfaces with
a rag.
40-4
2.
Apply a light coat of oil to non-gripping surfaces.
3.
Store in a safe, dry place.
|
