| |
Back
Using a Machinist's Bench Vise | Up
Tools And Their Uses - Hand tools and what they are used for | Next
Chapter 19 Clamps |
TM 9-243
USING A PIPE VISE
WARNING
PIPE ENDS ARE EXTREMELY SHARP.
HANDLE WITH CARE.
NOTE
The following procedure provides the
steps required to fasten a piece of pipe in
a hinged jaw pipe vise.
1
Open the pipe-holding jaws (1) by turning the
threaded T-handle (2)
Lift locking device (3) and open pipe vise.
3
Insert section of pipe (4) in vise and close pipe vise,
by pushing locking device against lip on the side of
the lower holding jaw (5).
4
Insert locking bolt through aligned holes of upper
and lower lip jaws.
CAUTION
Do not apply too much pressure to copper
or aluminum pipe.
5
Tighten the pipe holding jaws by turning the
threaded T-handle.
CARE OF VISES
Clean with a rag after each use, and apply a light coat
Never oil the swivel base or swivel joint, as this
of oil.
decreases its holding power.
Never strike avise with a heavy object or try to hold large
When not using a vise, bring the jaws lightly together
work in a small vise.
and leave the handle in a vertical position. This will
Keep jaws in good condition.
protect the jaws.
18-5/(18-6 blank)
|
