Staples

Specialty Nails Figure 3-77 shows a few of the many specialized nails. Some nails are specially coated with zinc, cement, or resin materials. Some have threading for increased holding power of the nails. Nails are made from many materials, such as iron, steel, copper, bronze, aluminum, and stainless steel. Annular and spiral nails are threaded for greater holding power. They are good for fastening paneling or plywood flooring. The drywall nail is used for hanging drywall and has a special coating to prevent rust. Roofing nails are not specified by the penny system; rather, they are referred to by length. They are available in lengths from 3/4 inch to 2 inches and have large heads. The double-headed nail, or duplex-head nail, is used for temporary construction, such as form work or scaffolding. The double head on this nail makes it easy to pull out when forms or scaffolding are torn down. Nails for power nailing come in rolls or clips for easy loading into a nailer. They are coated for easier driving and greater holding power. Table 3-10 gives the general size and type of nails preferable for specific applications. STAPLES Staples are available in a wide variety of shapes and sizes, some of which are shown in figure 3-78. Heavy-duty staples are used to fasten plywood sheeting and subflooring. Heavy-duty staples are driven by electrically or pneumatically operated tools. Light-duty and medium-duty staples are used for attaching molding and other interior trim. Staples are sometimes driven in by hand-operated tools. SCREWS The use of screws, rather than nails, as fasteners may be dictated by a number of factors. These may include the type of material to be fastened, the requirement for greater holding power than can be obtained by the use of nails, the finished appearance desired, and the fact that the number of fasteners that can be used is limited. Using screws, rather than nails, is more expensive in terms of time and money, but it is often necessary to meet requirements for superior results. The main advantages of screws are that they provide more holding power, can be easily tightened to draw the items being fastened securely together, are neater in appearance if properly driven, and can be withdrawn without damaging the material. The common wood screw is usually made of unhardened steel, stainless steel, aluminum, or brass. The steel may be bright finished or blued, or zinc, cadmium, or chrome plated. Wood screws are threaded from a gimlet point for approximately two-thirds of the length of the screw and are pro- vided with a slotted head designed to be driven by an inserted driver. Wood screws, as shown in figure 3-79, are designated according to head style. The most common types are flathead, oval head, and Figure 3-77.-Specialized nails. Figure 3-78.-Types of staples. 3-54