Operator’s Controls (Cont)

TM 55-4920-413-13&P Table 3-1. Operator’s Controls (Cont) Control, indicator or connector GAS GEN SPEED NO. 2 NOR CAL switch HI LO switch Variable control HIGH OIL TEMP NO. 1 HIGH OIL TEMP NO. 2 ENGINE OUT NO. 1 ENGINE OUT NO. 2 ENGINE % RPM NO. 1 NOR CAL switch HI LO switch Variable control ENGINE % RPM NO. 2 NOR CAL switch HI LO switch Variable control TORQUE NO. 1 NOR CAL switch HI LO switch Variable control TORQUE NO. 2 NOR CAL switch HI LO switch Variable control Function Permits selection of mode of operation for equipment testing of Ng #2 indicator. Permits selection of high and low calibration tests for Ng #2 indicator when NOR CAL switch is placed to CAL. Used to check range of operation of Ng #2 indicator when NOR CAL switch is placed to NOR. Used to indicate simulated conditions which exist on appropriate parameter tests. Used to select mode of operation: normal or calibration of % RPM #1 indicator. Used to select high and low speed calibration points of % RPM #l indicator when NOR CAL switch is placed to CAL. Used when NOR CAL switch is placed to NOR, to check operation of % RPM Engine #l indicator over its range. Selects mode of operation for % RPM #2 indicator - normal or calibration. Used to select high and low calibration points for % RPM #2 indicator when NOR CAL switch is placed to CAL. Used when NOR CAL switch is placed to NOR, to check operation of % RPM #2 indicator over its range. Used to select mode of testing - normal or calibration of % TRQ #1 indicator. Permits selection of high and low calibration of % TRQ #1 indicator checks when NOR CAL switch is placed to CAL. Permits testing of range of operation of the % TRQ #1 indica- tor system when NOR CAL switch is at NOR. Used to select mode of testing - normal or calibration of % TRQ #2 indicator. Permits selection of high and low calibration checks of % TRQ #2 indicator when NOR CAL switch is placed to CAL, Permits testing of range of operation of % TRQ #2 indicator system when NOR CAL switch is at NOR. 3-5