|
| |
Back
Figure 2-1. Typical Packaging | Up
TM-55-4920-410-13P Vibrex Balancing Kit Part No. D4591 Manual | Next
CHAPTER 3 OPERATING INSTRUCTIONS |
TM 55-4920-410-13&P
Section III. INSTALLATION INSTRUCTIONS
2-4. Installation of Equipment.
connector from the generator control unit receptacle.
Connect the adapter cable in series between the gen-
Connect adapter cable connector P1 to AIRCRAFT
erator control unit and its receptacle. Plug adapter
receptacle J1 on the test set front panel. In the helicop-
cable connector P3 into the helicopter connector which
ter, connect the grounding cable between the test set
was disconnected from the generator control unit.
and a suitable helicopter ground. Then disconnect the
Connect adapter cable P2 to the generator control unit.
2-3/(2-4 blank)
|
