|
| |
Back
CLUTCH SLAVE CYLINDER ADJUSTMENT | Up
TM-5-2420-224-20-2 Tractor Wheeled 4x4 DED Small Equipment Excavator (SEE) Manual | Next
I N S T A L L A T I O N |
TM 5-2420-224-20-2
CLUTCH MASTER CYLINDER REPLACEMENT
This task covers:
a. Removal b. Installation
INITIAL
SETUP
Tools and Special Equipment:
Equipment Condition:
Shop Equipment, SC 4910-95-CL-A74
Reference
TooI Kit, SC 5180-90-CL-N26
Condition Description
Page 4-15
Clutch Hydraulic
Materials/Parts:
Reservoir Removed
Washer, Lock (2)
Caps and Plugs
Appendix C, Item 7
Page 4-388
Outside Engine Hood
Removed
Rags
Appendix C, Item 32
W A R N I N G
Fuel and oil are slippery and
c a n c a u s e f a l l s . T o a v o i d
injury, wipe up spilled fuel or
oil with rags.
C A U T I O N
Cap or plug all ports and ends of hoses and tubes to prevent contamination
of hydraulic oil. Failure to do so may result in damage to equipment.
NOTE
Have container available to catch any fluid that may leak out of line or cylinder.
1.
REMOVE LINE (1) from clutch master cylinder (2). INSTALL CAP or PLUG.
2.
REMOVE two screws (3), two lock washers (4), and clutch master CYLINDER (2). DISCARD lock
WASHERS.
3.
FROM INSIDE CAB, REMOVE rubber protection BELLOWS (5) from end of clutch master cylinder (2).
4-22
|
