Tool and Test Equipment Requirements (Section III )

TM 11-7440-278-14

Column 6, Remarks. Column 6 contains an

column 3. This figure represents the active time required

to perform that maintenance function at the indicated

alphabetic code which leads to the remark in section IV,

category of maintenance. If the number or complexity of

Remarks, which is pertinent to the items opposite the

the tasks within the listed maintenance function vary at

particular code.

different maintenance categories, appropriate "work

time" figures will be shown for each category. The

D-4.

Tool and Test Equipment Requirements (Sect

number of taskhours specified by the "work time" figure

III)

represents the average time required to restore an item

a. Tool or? Test Equipment Reference Code.

(assembly, subassembly, component, module, end item

The numbers in this column coincide with the numbers

or system) to a serviceable condition under typical field

used in the tools and equipment column of the MAC.

operating conditions. This time includes preparation time,

The numbers indicate the applicable tool or test

troubleshooting time, and quality assurance/quality

equipment for the maintenance functions.

control time in addition to the time required to perform

b. Maintenance Category. The codes in this

the specific tasks identified for the maintenance

column indicate the maintenance category allocated the

functions authorized in the maintenance allocation chart.

tool or test equipment.

Subcolumns of column 4 are as follows:

c. Nomenclature. This column lists the noun

C - Operator/Crew

name and nomenclature of the tools and test equipment

0 - Organizational

required to perform the maintenance functions.

F - Direct Support

d. National/NATO Stock Number. This column

H - General Support

lists the National/NATO stock number of the specific tool

D - Depot

or test equipment.

e. Column 5, Tools and Equipment. Column 5

e. Tool Number-.

This column lists the

specifies by code, those common tool sets (not individual

manufacturer's part number of the tool followed by the

tools) and special tools, test, and support equipment

Federal Supply Code for manufacturers (5-digit) in

required to perform the designated function.

parenthesis.

D-5.

Remarks (Sect IV) Not applicable.

(Next printed page is D-3)

D-2