Figure 3-3. POWER DISTRIBUTION PANEL for V-460/MYK-8(V)

TM 11-7440-278-14

(19)

Inform the data processing equipment

operator that unit power is available.

b. OL-89(V) (*)/MYK-8(V). To apply power to the

equipment in the OL-89(V) (*)/MYK-8 (V), perform (1)

through (14) of paragraph 3-30, and the following

procedures:

(1) Turn on the tape control (2804-2) cir-cuit

breaker on the ADP power load center (A9).

(2) Turn on the direct access storage (2314)

circuit breaker on the ac service load center (A6).

(3) Turn on the M.T. unit test receptacle circuit

breaker on the ac service load center (AG).

(4) Inform the data processing equipment

operator that unit power is available.

(5) Ensure that the intercom unit power switch

is on.

c. V-460/MYK-8(V).

(1) Operate the POWER DISTRIBUTION

PANEL MAIN circuit breaker to ON.

(2) Operate the POWNER DISTRIBUTION

PANEL LIGHTS circuit breaker to ON, and the

FLUORESCENT LIGHTS switch to ON.

(3) If blackout conditions are required, operate

the BYPASS BLACKOUT switch to OFF; otherwise

operate it to ON.

3-4.

ADPE Operation

Refer to the applicable publication listed in appendix A

for the operation of IBMI 129 Card Data Recorder.

3-5.

Stopping Procedures

NOTE

In a routine power shutdown, the OL 88(V) (* )/MYK-8(V)

is the last van to be stopped.

a. V-460/MYK-8(V).

(1) Turn off equipment power switches as

described in the applicable manuals listed in appendix A.

(2) Turn circuit breakers on the POWER

DISTRIBUTION PANEL to OFF.

(3) Turn light switches to OFF.

b. OL-88(V)(*)/MYK-8(V) and OL-89(V)(*)/MYK-8

(V).

Figure 3-3. POWER DISTRIBUTION PANEL for V-

(1) Have a qualified personnel cycle ADP

460/MYK-8(V)

equipment down.

(14)

Energize ADP main power circuit breaker.

(2) Press power switch OFF pushbutton on

(15)

Turn on the control unit (2821-1) cir-cuit breaker

CPU console).

on the ADP power load center (A9).

(3) Turn off each circuit breaker on the ADP

(16)

Turn on the processing unit (2030) cir-cuit

load center.

breaker on the ADP power load center (A9).

(4) Turn off ADP power main circuit breaker

(17)

Turn on the CMI1 memory circuit breaker.

(A7).

(18)

Verify that all equipment is receiving power.

3-4