Section IV. PRELIMINARY ADJUSTMENT OF EQUIPMENT

TM 11-7440-278-14

Figure 2-5. Sunshade Installation.

c. Insert each standoff rod into its corresponding

ladder can be used to gain access to the van roof. Install

the shade as follows:

grommet.

a. Install support assembly and standoff rods.

d. Secure the shade by fastening the shade's nylon

b. Starting from either the front or rear of the van,

ropes to their associated van tie-down hooks.

unroll the shade over the support assembly.

Section IV. PRELIMINARY ADJUSTMENT OF EQUIPMENT

properly emplaced and is in a condition ready for

2-10. Extent of Preliminary Checks and Adjustments

operation.

The preliminary checks and adjustments for the

AN/MIYK8(V) (*) consist of grounding the assemblages,

2-11. Grounding

connecting power, and then performing a check of the

power, lighting, and climate control system. These

The assemblages, including the prime power distribution

procedures ensure that the AN/MYK-8(V) (*) has been

box and the power generator (if one is used), must be

properly grounded before signal

2-6