CHAPTER 3 OPERATOR'S MAINTENANCE

TM 11-7021-202-12

CHAPTER 3

OPERATOR'S MAINTENANCE

3-1.

GENERAL

This chapter provides the Operator's maintenance instructions and procedures for Data

Processing Set AN/UYK-64 (V). Operator Maintenance is limited to cleaning and replacing

fuses.

3-2.

LUBRICATION

No lubrication or lubricants are required.

3-3.

CLEANING

The following cleaning procedure is to be performed by the Operator as required.

(1)

Remove dust and dirt from exterior surfaces using a clean, lint-free cloth

(item 3, appx E).

Isopropyl alcohol is extremely flammable; use

in well ventilated area away from fire, sparks,

or any other heat source. When not in use,

keep alcohol container closed.

(2)

Remove grease using a clean, line-free cloth (item 3, appx E) soaked with

isopropyl alcohol (item 1, appx E). Wipe dry using a clean, lint-free cloth.

(3)

Use a bristle brush (item 2, appx E) to remove dirt from hard to reach areas.

Verify that the ETM indicator appears to be operating.

(4)

Remove caked-on dirt using a bristle brush (item 2, appx E) soaked with

(5)

isopropyl alcohol (item 1, appx E). Wipe dry using a clean, lint-free cloth

(item 3, appx E).

3-1