|
| |
Back
TABLE 2-1 (92221P) BGU to LaserJet pin out | Up
TM-11-5895-1412-12P Basic Generation Unit AN/GYK-33 (NSN 5895-01-260-4545) (EIC:N/A) Manual | Next
LOAD FROM DISK |
TM ll-5895-1412-12&P
Page
Loading the BGU Program . . . . . . . . . . . . . . . . . . . . . . 2-12
SOI/CEOI Menu . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-12
Load From Disk . . . . . . . . . . . . . . . . . . . . . . . . . .2-13
Save To Disk . . . . . . . . . . . . . . . . . . . . . . . . . . .2-14
Zeroize Computer . . . . . . . . . . . . . . . . . . . . . . . . .2-15
DOS Commands . . . . . . . . . . . . . . . . . . . . . . . . . . .2-15
Conv Database . . . . . . . . . . . . . . . . . . . . . . . . . .2-15
Version I. . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-16
Xfer SOI/CEOI. . . . . . . . , . . . . . . . . . . . . . . . . . .2-16
Gen Callsigns. . . . . . . . . . . . . . . . . . . . . . . . . . .2-17
Gen Suf/Exp. . . . . . . . . . . . . . . . . . . . . . . . . . . .2-17
Gen Sign/Cntr. . . . . . . . . . . . . . . . . . . . . . . . . . .2-17
Gen Frequency. . . . . . . . . . . . . . . . . . . . . . . . . . .2-17
Gen Sincgars . . . . . . . . . . . . . . . . . . . . . . . . . . .2-17
Gen Smoke/Pyro . . . . . . . . . . . . . . . . . . . . . . . . . .2-17
Format C Drive . . . . . . . . . . . . . . . . . . . . . . . . . .2-17
LOADING THE BGU PROGRAM
1.
Ensure all of the components are properly connected as specified in
Section II, page 2-6.
2.
Ensure the configurations are properly set as specified in Entering
System Configuration, page 2-8.
3.
Remove the transit disk from the disk drive if one is present.
4.
Insert the BECS Version I Program disk into the disk drive.
5.
Press <f4> Reread Disks.
The PAM menu then displays the screen shown in
Figure 2-4.
6.
Move the cursor arrow using the arrow keys to “SOI/CEOI MENU” and press
<f1> Start Applic or the <RETURN> key. The screen then displays,
Loading “SOI/CEOI MENU”
When the SOI menu is finished loading, the screen shown in Figure 2-5 is
displayed.
NOTE:
You need a blank formatted floppy disk to save the database. This disk is
referred to as the data disk. (See Format C Drive, page 2-17 for the
procedures to format a disk.)
This PAM selection creates the BGU PAM menu.
Use this option if the PAM menu
does not have all of the necessary selections.
2-12
|
