TM-11   5895-1412-12&P Signals RS-232-C (CD) DTR (BA) TxD (BB) RxD (CA)  RTS (CB)  CTS (CC) DSR (AB) GND (CF) DCD (NOT USED) Signals V.24 108/2 103 104 105 106 107 102 109 9-Pin 25-Pin (Male) (Male) V . 2 4 1 2 3 4 5 6 7 8 9 SHIELD SHELL 1 DRAIN 6 3 2 8 20 7 4 5 RS-232-C DSR (CC) RxD (BB) TxD (BA) DCD (CF) DTR (CD) GND (AB) RTS (CA) CTS (CB) 107 104 103 109 108/2 102 105 106 TABLE 2-1 (92221P) BGU to LaserJet pin out B. ENTERING  SYSTEM  CONFIGURATION From  the  Personal  Applications  Manager  (PAM)  menu  shown  in  Figure  2-1,  press <f6>. If a disk is-present in the disk-drive,   this screen may look different. Notice the f6 in parenthesis following the figure caption. These hints appear throughout  this  document  to  show  the  keystroke(s)  leading  up  to  the  screen from the PAM menu. If connecting to the LaserJet through the HP 82164A interface, set the  Printer Interface  parameter to HP 82164A instead of Serial. c. ENTERING  DATACOM  CONFIGURATION Datacom  configuration  must  be  set  for  system  components  to  link-up  and exchange data. Use the arrow keys to move from line-to-line (see Fiqure 2-31. Use  the  serial  column  when  connecting  the the HP 82164A column when using the HP 82 ready to print to the LaserJet. NOTE: Refer to Appendix L for Print Menu LaserJet to the serial port. Use ‘ 164A  interface. The  computer  is  now and  Configuration  Menu. 2-11