Section II. OPERATION UNDER USUAL CONDITIONS

TM 11-5895-1412-12&P Section II. OPERATION UNDER USUAL CONDITIONS Page Connections for Loading the DTD and ECCM Fill Device . . . . . . . . . . . . . . . . . . . . . 2-7 Connections For Operation . . . . . . . . . . . . . . . . . . 2-6 Making Connections . . . . . . . . . . . . . . . . . . . . . 2-6 Required Devices and Peripherals . . . . . . . . . . . . . . 2-6 Turning On/Off Devices . . . . . . . . . . . . . . . . . . . 2-7 Computer AC Rechargers Paper Disc Drive Battery Packs Jet Ink Printer Loop and Interface Cables Flexible Disc The following will help determine how devices should be connected. CONNECTIONS FOR OPERATION Each device comes with a Interface Loop (IL) cable and has IN and OUT interface ports on the back panel as shown below. The ports have the following uses going from left to right: OUTPUT (large end of the HP-IL cable) INPUT (small end of the HP-IL cable) POWER (port for AC adapter) Use the HP-IL cables to connect the system components, as shown below. It Is Important that all components be connected by two cables. The printer may be positioned on the disc drive during operation however allow a place for tractor type paper If being used. 2-6