Tool and Test Equipment Requirements

TM 11-5820-803-12

L-Selected repair activity (SRA). If a SRA facility

b. Column 2, Component/Assembly. Column 2

is not available, this category of maintenance

contains the noun names of components, assemblies,

will be accomplished at a depot

subassemblies, and modules for which maintenance is

D-Depot

authorized.

e. Column 5, Tools and Equipment. Column 5

c. Column 3, Maintenance Functions. Column 3

specifies by code, those common tools sets (not

lists the functions to be performed on the item listed in

individual tools) and special tools, test, and support

column 2. When items are listed without maintenance

equipment required to perform the designated function.

functions, it is solely for purpose of having the group

numbers in the MAC and RPSTL coincide.

C-4.

Tool and Test Equipment Requirements

d. Column 4, Maintenance Category. Column 4

(Table 1)

specifies, by the listing of a "worktime" figure in the

a. Tool or Test Equipment Reference Code. The

appropriate subcolumn(s), the lowest level of

numbers in this column coincide with the numbers used

maintenance authorized to perform the function listed in

in the tools and equipment column of the MAC. The

column 3. This figure represents the active time required

numbers indicate the applicable tool or test equipment

to perform that maintenance function at the indicated

for the maintenance functions.

category of maintenance. If the number or complexity of

the tasks within the listed maintenance function vary at

b. Maintenance Category.

The codes in this

different maintenance categories, appropriate "worktime"

column indicate the maintenance category allocated the

figures will be shown for each category. The number of

tool or test equipment.

man-hours specified by the "worktime" figure represents

c. Nomenclature. This column lists the noun name

the average time required to restore an item (assembly,

and nomenclature of the tools and test equipment

subassembly, component, module, end item or system)

required to perform the maintenance functions.

to a serviceable condition under typical field operating

d. National/NATO Stock Number. This column lists

conditions.

This time includes preparation time,

the National/NATO stock number of the specific tool or

troubleshooting time and quality assurance/quality

test equipment.

control time in addition to the time required to perform

e. Tool Number.

This column lists the

the specific tasks identified for the maintenance

manufacturer's part number of the tool followed by the

functions authorized in the maintenance allocation chart.

Federal Supply Code for manufacturers (5-digit) in

parentheses.

Subcolumns of column 4 are as follows:

O-Operator/crew

O-Organizational

F-Direct support

Change 1 C-2