SECTION I INTRODUCTION

SECTION I

INTRODUCTION

1-1. Scope

Code

Explanation

This manual lists repair parts and special tools required

for the performance of organizational maintenance of the

PD - Support item, excluding support equipment,

AN/TXC-1, AN/TXC-1A, AN/TXC-1B, AN/TXC-1C, and

procured for initial issue or outfitting and stocked

AN/TXC-1D. The PCCN for the equipment is GCWANT

only for subsequent or additional initial issues or

for all models.

outfittings.

Not subject to automatic

replenishment.

1-2. General

PE - Support equipment procured and stocked for initial

This repair parts and special tools list is divided into the

issue or outfitting to specified maintenance

following sections:

repair activities.

a. Prescribed Load Allowance (PLA) - Section II.

PF - Support equipment which will not be stocked but

Not applicable.

which will be centrally procured on demand.

b. Repair Parts List - Section III. A list of repair

PG - Item procured and stocked to provide for

parts authorized for the performance of maintenance at

sustained support for the life of the equipment.

the organizational level. This repair parts list is arranged

It is applied to an item peculiar to the equipment

in alphabetical order.

which because of probable discontinuance or

c. Special Tools, Test and Support Equipment -

shutdown of production facilities would prove

Section IV. Not applicable.

uneconomical to reproduce at a later time.

d. Index - Federal Stock Number and Reference

KD - An item of depot overhaul/repair kit and not

Number Cross-Reference to Figure and Item Number -

purchased separately. Depot kit defined as a kit

Section V. A list, in ascending numerical sequence, of

that provides items required at the time of

all Federal stock numbers appearing in the listings,

overhaul or repair.

followed by a list, in alphanumeric sequence, of all

KF - An item of a maintenance kit and not purchased

reference numbers appearing in the listings. Federal

separately. Maintenance kit defined as a kit that

stock number and reference numbers are cross-

provides an item that can be replaced at

referenced to each illustration figure and item number or

organizational or direct support or general

reference designation appearance.

support levels of maintenance.

KB - Item included in both a depot overhaul/repair kit

1-3. Explanation of Columns

and a maintenance kit.

The following provides an explanation of columns in the

MO - Item to be manufactured or fabricated at

tabular lists-

organizational level.

a. Source, Maintenance, and Recoverability Codes

IMF - Item to be manufactured or fabricated at direct

(SMR).

support maintenance level.

(1) Source code.

Indicates the manner of

MH - Item to be manufactured or fabricated at general

acquiring support items for maintenance, repair, or

support maintenance level.

overhaul of end items. Source codes are -

MD - Item to be manufactured or fabricated at depot

maintenance level.

Code

Explanation

AO - Item to be assembled at organizational level.

AF - Item to be assembled at direct support

PA - Item procured and stocked for anticipated or

maintenance level.

known usage.

AH -- Item to be assembled at general support

PB - Item procured and stocked for insurance purposes

maintenance level.

because essentiality dictates that a minimum

AD - Item to be assembled at depot maintenance level.

quantity be available in the supply systems.

XA - Item is not procured or stocked because the

PC - Item procured and stocked and which otherwise

requirements for the item will result in the

would be coded PA except that it is deteriorative

replacement of the next higher assembly.

in nature.

XB - Item is not procured or stocked. If not available

through salvage, requisition.

XC - Installation drawing, diagram instruction