CLEANING AND INSPECTION

TM 9-2350-222-34-1

FUEL TANKS (LEFT AND RIGHT) LOWER REAR MOUNT REPLACEMENT (Sheet 3 of 4)

CLEANING AND INSPECTION:

1. Clean rubber mounts with detergent (Item 11,

Appendix B) and water. Rinse clean with water.

2. Clean all metal parts with dry cleaning solvent (Item

12, Appendix B). Wipe dry with rags.

3. Visually inspect rubber

mounts

for

cuts,

deterioration, or wear.

4. Visually inspect metal parts for wear.

5. Replace unserviceable parts.

INSTALLATION:

1. Install rubber mount (A) and washer (B) between

holding brackets (C and D).

2. Insert screw (F) through washer (E) and holding

brackets (C and D), then install rubber mount (G),

washer (H), lockwasher (J), and nut (K).

3. Using 15/16 inch socket on screw (F) and 15/16 inch

wrench on nut (K), tighten screw (F) and nut (K).

Go on to Sheet 4

TA130489

4-25