CLEANING

TM 9-2350-222-34-1

ENGINE REPLACEMENT (20 ENGINE) (Sheet 9 of 18)

30. Using fabricated wrench and 5/8 inch socket,

remove screw (AV), nuts (AW), and washer (AX)

from left and right side of transmission.

31. Using fabricated wrench or 5/8 inch wrench, remove

17 screws (AY), lockwashers (AZ), and washers

(BA) that secure transmission to engine.

32. Carefully move transmission rearward to separate

from engine.

33. Using hands, grasp wiring harness (AP) and

carefully pull towards transmission until grommet

(AQ) and cannon plug (AN) are free of shroud.

34. Remove transmission-to-engine preformed packing

(BB). Throw packing away.

Dry cleaning solvent PD680 Is toxic and flammable.. To prevent personal injury, wear protective

goggles and gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and

clothes and don't breathe vapors. Do not use near open flame or excessive heat. The flash point

for type #1 Dry Cleaning Solvent is 1000F (380C) and for Type 1#2 is 1380F (500C). If you become

dizzy while using cleaning. solvent, get fresh air immediately and get medical aid. If contact with

eyes is made, wash your eyes with water and get medical aid immediately.

Clean all parts that have been removed from transmission and engine with dry cleaning solvent. Wipe dry with clean, lint-

free rags.

Go on to Sheet 10

Change 3 3-26