REMOVAL

TM 9-2350-222-34-1

ENGINE REPLACEMENT (2D ENGINE) (Sheet 3 of 18)

REMOVAL:

1. Using 1-1/8 inch wrench, loosen connection

(A). Remove line (B) from engine.

2. Using hand, remove lead (C) from fuel

solenoid (D).

NOTE

Tag oil cooler tubes as they are

removed for later installation.

Removal of left and right side

oil cooler tubes are the same.

NOTE

When removing the oil cooler

tubes, remove the outer tube

and

its

adapter

before

removing the inner tube and its

adapter

3. Using 1-5/8 inch wrench to hold adapter (E), use

1-1/2 inch wrench to remove outer nut (F) securing

outer tube (G). Pull outer tube (G) towards

transmission until it is free of outer adapter (E).

4. Using 1-5/8 inch wrench, remove outer adapter (E)

and washer (H) from oil cooler (J).

5. Perform steps 3 and 4 to remove the inner oil cooler

tube (G), the inner adapter (E), and washer (H) from

oil cooler (J).

TA130451

Go on to Sheet 4

3-20