ENGINE REPLACEMENT (2D ENGINE) (Sheet 1 of 18)

TM 9-2350-222-34-1

ENGINE REPLACEMENT (2D ENGINE) (Sheet 1 of 18)

PROCEDURE INDEX

PROCEDURE

PAGE

Removal

3-20

Cleaning

3-26

Installation

3-27

TOOLS:

Ratchet with 1/2 in. drive

3/4 in. combination box and open end

7/16 in. combination box and open end

wrench

wrench (2 required)

1-3/16 in. open end wrench

7/8 in. combination box and open end

5/8 in. combination box and open end

wrench

1 in. combination box and open end

1-1/8 in socket with 1/2 in. drive

wrench

5 in. extension with 1/2 in. drive

1-1/8 in. open end wrench

Flat-tip screwdriver

1-1/2 in. open end wrench

Spanner wrench

1-5/8 in. open end wrench

Retaining ring pliers

1/2 in. socket with 1/2 in

drive. Torque wrench with 1/2 in. drive (0-175 1b-

1/2 in. combination box and open end

ft) (0-237 N.m)

wrench

5/8 in. socket with 1/2 in drive

Transmission sling (7081593)

Puller attachment (7082201)

SPECIAL TOOLS: Pinion turning wrench (Item 5, Chapter 2, Section I) Engine and transmission sling (Item 1,

Chapter 2, Section I) Mechanical puller adapter (Item 2, Chapter 2, Section I)

FABRICATED TOOLS:

Wrench (Item 1, Appendix D)

SUPPLIES:

Gasket (10864007)

Rags (Item 31, Appendix B)

Preformed packing (7723892)

Wooden blocks, 10 x 10 x 12 in.

Drain pan

(2 required)

Gloves (Item 13.1, Appendix B)

I.D. tags

Dry cleaning solvent (Item 12,

Goggles (Item 13.2, Appendix B)

Appendix B)

Gasket (7767860)

REFERENCES:

TM 9-2350-222-20-1

LO 9-2350-222-12

PERSONNEL: Two

PRELIMINARY PROCEDURES:

Remove powerplant (TM 9-2350-222-20-1)

Remove steering linkage and brackets (TM 9-2350222-20-1)

Remove shifting linkage and brackets (TM 9-2350-222-20-1)

Remove engine shroud and supports (TM 9-2350-22220-1)

Remove engine mounts (IM 9-2350-22220-1)

Remove right angle drive, clutch, and pump (TM 9-2350-222-20-1)

Remove generator exhaust valve (TM 9-2350-222-20-1)

Go on to Sheet 2

All data on pages 3-2 thru 3-17 deleted.

Change 5 3-18