WARNING-continued

TM 9-2350-222-34-1

WARNING

HIGH VOLTAGE

Used in the operation of this equipment

DEATH ON CONTACT

May result if personnel fail to observe safety precautions.

Never work on electronic equipment unless there is another person nearby who is familiar with the operation and hazards

of the equipment and who is competent in administering first aid. When a technician is aided by operators, he must warn

them about dangerous areas.

Whenever possible, the master battery switch and battery ground straps should be either turned off or disconnected before

beginning work on the equipment.

Whenever the nature of the operation permits, keep one hand away from the equipment to reduce the hazard of current

flowing through vital organs of the body.

Before you work around tracked vehicles, remove rings, bracelets and wrist watches. These items may be caught on

projections and cause injury or may be shorted across an electrical circuit and cause severe burns and electrical shock.

For artificial respiration, refer to FM 21-11.

Dry cleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and gloves and use only in a well-

ventilated area. Avoid contact with skin, eyes, and clothes and don't breathe vapors. Do not use near open flame or

excessive heat. The flash point for Type il Dry Cleaning Solvent is 100°F (38°C) and for Type #2 is 138°F (50°C). If you

become dizzy while using cleaning solvent, get fresh air immediately and get medical aid. If contact with eyes is made,

wash your eyes with water and get medical aid immediately.

Wear goggles and cover relief valve with a rag to prevent grease from getting in eyes. Relief valve opens at 2150-2250

psi and blows a fine spray of grease.

Change 2 c