TM 9-2350-222-20-1-5
MATERIAL
FABRICATING
REQUIREMENT
DESCRIPTION
If using 20 ft. wire, cut
1.
Connector, electrical
in 10 ft. lenghts and
connect to connector
Wire, black, electrical
(A).
16 ga., 20 ft. lg
If using optional wire,
2.
Wire, black, electrical
connect one black wire
16 ga., 10 ft. lg.
and one red wire to
connector (A).
Wire, red, electrical
16 ga., 10 ft. lg.
Wrap electrician's tape
3.
around both wires at
Wire, black, electrical
connector.
16 ga., 10 ft. lg.
Cut two 3 inch long
4.
Wire, red, electrical
pieces of heat shrink
16 ga., 10 ft. lg.
tubing and slide one
piece onto each wire.
Power clip (2 required)
Screw (2 required)
5.
to each wire.
Heat shrink tubing, 1 ft. lg
6.
Connect lug terminals
Lug Terminal
to power clips with
screws and bend ears
of power clips over
wires.
Electricians tape (Item 59,
7.
Slide heat shrink
tubing onto power
clip connection and
using heat gun, shrink
tubing.
Figure F-7. Fuel-Water Separator Test Cable
TA141275
F-7