TM 9-2350-222-20-1-5
REAR DRAIN VALVE LINKAGE ADJUSTMENT (Sheet 2 of 7)
5. Adjust clevis (C) until holes in clevis and hole
in lever (E) can be lined up using clevis pin (B).
6. Using fingers, tighten jamnut (G) against clevis
(c).
7. Measure threads on rod (H):
If threads measure one inch or lees, go to
step 14.
If threads are more than one inch, go to step
8.
NOTE
Coupling jamnut (J) can be reached from engine compartment
(L). Open or close rear drain valve, if necessary, to put wrench
on coupling jamnut (J).
Using wrench, been coupling jamnut (J) all the way while holding coupling (K) with wrench.
8.
TA140775
16-163