FRONT FENDERS, HEADLIGHT GUARDS, AND OUTRIGGERS REPLACEMENT (Sheet 1 of 7)

TM 9-2350-222-20-1-5

FRONT FENDERS, HEADLIGHT GUARDS, AND OUTRIGGERS REPLACEMENT (Sheet 1 of 7)

PROCEDURE INDEX

PROCEDURE

PAGE

Removal

Installation

TOOLS:

Ratchet with 1/2 in. drive

7/16 in. socket with 1/2 in. drive

7/16 in. combination box and open end wrench

9/16 in. socket with 1/2 in. drive

9/16 in. combination box and open end wrench

3/4 in. socket with 1/2 in. drive

3/4 in. combination box and open end wrench

1-1/8 in. socket with 3/4 in. drive

Ratchet with 3/4 in. drive

Torque wrench with 3/4 in. drive (0-600 lb-ft) (0-813 N·m)

SUPPLIES:

Lockwasher (MS35338-48) (2 required)

Lockwasher (MS35338-44) (13 required)

Lockwasher (MS35338-51) (8 required)

Self-locking nut (MS51988-7) (10 required)

PRELIMINARY PROCEDURES:

Remove personnel heater exhaust tube

(right fender only) (page 19-5)

Remove center stowage box (page 16-177)

REMOVAL:

NOTE

Right front fender, headlight guard, and outriggers shown.

Left front fender removal is similar.

Go on to Sheet 2

TA253573