TM 9-2350-222-20-1-4
STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 7 of 13)
25. Using 9/16 inch wrench, remove screw (Q).
Using 9/16 inch wrench, loosen jamnut (R).
26.
27. Remove steering rod end bearing (S) from clevis
(T).
28. Insert locating pin (P).
Using 9/16 inch wrench on steering rod end
29.
bearing flat (U), turn clockwise or
counterclockwise until steering control is
centered when screw (Q) is installed through
rod end bearing (S) and clevis (T).
Install screw (Q) finger tight through rod end
30.
bearing (S) and clevis (T).
31.
Using crowfoot wrench, adapter, and
torque wrench, tighten jamnut (R) to 15-
DRIVER'S STATION
20 lb-ft (20-27 N-m).
Remove locating pin (P).
32.
Using torque wrench with socket, tighten
33.
screw (Q) to 15-20 lb-ft (20-27 N-m).
34.
Insert locating pin (P).
GO on to Sheet 8
15-8 Change 5