TM 9-2350-222-20-1-4
PARKING BRAKE CONTROL ASSEMBLY AND LINKAGE REPLACEMENT
(DRIVER'S STATION) (Sheet 10 of 10)
Position clevis (AD) over lever (K) and install
22.
pin (AJ) through clevis (AD) and lever (K).
Using pliers, install new cotter pin (AK)
through pin (AJ).
Go to engine compartment. Route control
23.
assembly along right wall of engine
compartment.
Position clamp (AL) over control assembly (A).
24.
Using 7/16 inch wrench, install screw (AM) and
washer (AN) into mount on engine
compartment hull.
25.
Using 15/16 inch wrench, install nut (AP)
onto control assembly (A).
26.
Install new lockwasher (AQ), bracket (AR),
and new lockwasher (AS) onto control
assembly (A).
27.
Using 15/16 inch wrench, install nut (AT)
onto control assembly (A).
28.
Install new packing (AU) onto brake control
nut (AV).
Using 15/16 inch wrench, install new brake
29.
control nut (AV) onto control assembly (A).
Using 9/16 inch wrench, install nut (AW) onto
30.
control assembly (A).
Using 9/16 inch wrench to hold nut (AW), use
31.
adjustable wrench and install connector (AX)
onto control assembly (A).
32.
33.
Install right bulkhead access cover (page 16-34).
34.
End of Task
TA140419
13-114