TM 9-2350-222-20-1-4
PARKING BRAKE CONTROL ASSEMBLY REPLACEMENT (ENGINE COMPARTMENT)
(Sheet 10 of 15)
8.
Push packing with retainer (D) onto threaded
sleeve of control assembly.
9.
Thread nut (C) onto sleeve and finger tighten
on shaft.
10.
Using 9/16 inch wrench on flats (K) of control
assembly, use 15/ 16 inch wrench to tighten
nut (A) securely against housing.
NOTE
Your system may not have nut (L). If not
skip step 12.
11.
Using 9/16 inch wrench, thread nut (J) onto rod end to allow installation of another nut.
12.
Using fingers, install and tighten second nut (L) onto rod end.
13.
Push washer (E) and spring (F) downward and install new cotter pin (M) through hole in rod end.
14.
Using pliers, bend cotter pin (M) to prevent it from falling out.
15.
Install cover and new gasket (N).
16.
Using 7/16 inch socket, install eight nuts and new lockwashers (P).
Go on to Sheet 11
TA253444
Change 1
13-93