TM 9-2350-222-20-14
BRAKE RIGHT HAND SLAVE CYLINDER AND TUBE ASSEMBLY
(Sheet 4 of 6)
INSTALLATION:
1.
Insert new packing (A) in groove of slave
cylinder (B).
2.
Position and slide slave cylinder (B) down
over housing assembly push rod, Wiggle
slave cylinder back and forth while pushing
down. Push slave cylinder forward when -
on housing assembly, then pull back to
make sure catch engages in housing assembly,
3.
Tighten mounting nut (C) to stud, finger
tight.
4.
Using 9/16 inch socket, tighten mounting
nut (C).
5.
Using 9/16 inch socket, remove screw (D)
and lockwasher (E) from adjusting screw
lock plate. Throw lockwasher away.
6.
Position and aline adjusting screw lock
plate and bracket (F), Insert screw (D) and
new lockwasher (E) finger tight.
7.
Using 9/16 inch socket, tighten screw (D).
8.
Using fingers, connect tube assemblies (G)
and (H) and cap (J) to tee (K).
Go on to Sheet 5
TA253436
Change 1
13-67