TM 9-2350-222-20-1-4
ENGINE WIRING HARNESS REPLACEMENT (2D ENGINE) (Sheet 8 of 12)
2.
place cable (B) in position on starter (C) as
shown.
3.
Using flat-tip screwdriver, install screw (D)
securing cable (B) to starter (C).
4.
Place cable (E) in position on starter solenoid
(F).
5.
Place two other cables (G) on starter solenoid
(F).
6.
Using 3/4 inch wrench, install nut and new
lockwasher (H).
7.
Using spanner wrench, connect connector (J) to
low voltage protection device (K).
8.
Install two new plastic straps (L) around cables
(B), (E), and (G).
9.
Place connector (M) to ignition unit (N).
10. Place cable (P) and clamp (Q) in position.
11. Using 7/16 inch socket, install two screws
and clamp (Q).
12. Place clamp (S) (hidden) in position over
cables.
13. Using 1/2 inch socket, install nut securing
cables and clamp (S).
Go on to Sheet 9
TA139897
10-346