TM 9-2350-222-20-1-4
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR
MALE CONNECTOR REPAIR (Sheet 1 of 1)
TOOLS: Electrical connector repair tool kit
Diagonal cutting pliers
PRELIMINARY PROCEDURE:
1. Slide shell (A) back along cable (B).
2. Using diagonal cutting pliers, cut terminal
(C) and C-washer (D) from cable (B). Throw
terminal (C) and C-washer (D) away.
3. Using hand wire stripper, strip insulation from
cable (B) equal to well depth in terminal (C).
4. Insert stripped cable end (E) into well in
terminal (C).
5. Using crimping tool, crimp terminal (C).
6. Push new C-washer (D) onto cable (B) at rear
of terminal.
7. Slide shell (A) forward along cable (B) until tight against C-washer (D).
End of Task
TA139863
10-312