INSTALLATION-continued

TM 9-2350-222-20-1-4

STARTER REPLACEMENT (Sheet 7 of 7)

11. Using screwdriver, secure small cable (P) onto

bottom front of solenoid relay with screw and

external tooth lockwasher (Q).

12. Install heavy cables (R) and (S) and tagged light

cable (T) onto lower terminal of starter switch

relay solenoid (U). Using 3/4 inch socket and

torque wrench, secured cables with nut and

lockwashers (V) to 168-192 lb-in (19-22 N-m).

13. Install two double-braided ground straps (H)

and two heavy cables (X) and (Y) and tagged

light cable (Z) onto large terminal at starter

motor (AA). Using 3/4 inch socket and torque

wrench, secure cables with nut and new

lockwashers to 168-192 lb-in (19-22 N-m).

14.

Install starter low voltage relay solenoid (page 10-34) (2D engine only),

15.

Connect powerplant for gound hop (page 5-48).

16.

Start engine (TM 9-2350-222-10),

17. Stop engine (TM 9-2350-222-10).

18. Using pliers, secure four bracket bolts with

lockwire (Item 59, Appendix D) (AB), exactly

as shown in the figure, to prevent them from

loosening.

19. Coat all exposed terminal fittings with

glyptol (Item 38, Appendix D).

20. Disconnect ground hop kit (page 5-62).

21. Install 2A powerplant (page 5-14) or 2D

powerplant (page 5-37).

End of Task

TA139587

10-32