INSTALLATION-continued

TM 9-2350-222-20-1-4

STARTER REPLACEMENT (Sheet 6 of 7)

Slide starter cradle assembly bracket (E) int

position on starter (C).

Using fingers, install three screws (F) with flat

washers to secure starter cradle assembly

bracket (E) to engine oil pan (G).

NOTE

When

installing

double-braided

ground strap (H) to screw (J),

make sure flat washer seats flat

against bracket face.

Using fingers, install double-braided ground strap (H) with screw and flat washer (J), and install

screw to starter cradle assembly bracket (E) and engine oil pan (G) as in step 6.

Using 1/2 inch wrench, tighten two

self-locking nuts evenly to be sure nuts and

U-bolts seat properly.

Using 9/16 inch socket and extension, secure

four screws and flat washers (F) and (J).

NOTE

After securing bolts and flat

washers (F) and (J), check front

of starter case to be sure there

is no gap between starter case

and support cradle assembly. If

there is a gap, loosen bolts (F)

and (J) and adjust position of

cradle assembly so there is no

gap.

10. Using 1/2 inch socket and extension, secure low voltage relay solenoid bracket (L) to engine oil

pan (G) with four screws (M) and new lockwashers (N).

Go on to Sheet 7

TA139586

10-31