REMOVAL-continued

TM 9-2350-222-20-1-4

STARTER REPLACEMENT (Sheet 4 of 7)

NOTE

The top and front fasteners have

bolts (Y) which pass through the

engine hull housing (AA) and must

be held in place when removing

The

t h e self-locking nuts [Z).

inboard fastener has a stud and

will not require a wrench to hold it

in place.

10.

Using 15/16 inch wrench on bolts (Y) and

special wrench (Item 3, Chapter 3, Section I) on

seif-locking nuts (Z), loosen and remove three

self-locking nuts (Z) securing starter (F) to

starter drive adapter (AB). Throw nuts away.

11.

Using two persons, ease starter out of starter drive adapter (AB). Remove starter from engine.

12. Remove gasket (AC) from starter drive adapter (AB). Throw gasket away.

Go on to Sheet 5

TA 139584

10-29