STARTER REPLACEMENT (Sheet 1 of 7)

TM 9-2350-222-20-1-4

STARTER REPLACEMENT (Sheet 1 of 7)

PROCEDURE INDEX

PAGE

PROCEDURE

Removal

Installation

1/2 in. combination box and

TOOLS: Diagonal cutting pliers

open end wrench

Flat-tip screwdriver

3/4 in. combination box and

Slip joint pliers

open end wrench

Ratchet with 1/2 in. drive

13/16 in. combination box and

10 in. extension with 1/2 in. drive

open end wrench

1/2 in. socket with 1/2 in. drive

15/ 16 in. combination box and

3/4 in. socket with 3/8 in. drive

open end wrench

9/16 in. socket with 1/2 in. drive

Torque wrench with 3/8 in. drive

3/4 in. socket with 1/2 in. drive

(0-200 lb-in.) (0-22 N-m)

SPECIAL TOOLS: Ground hop kit (Item 30, Chapter 3, Section I)

Wrench, open end (Item 3, Chapter 3, Section I)

SUPPLIES: Pencil

Two tags

Lockwire (10 in.) (Item 59, Appendix D)

Glyptol (Item 38, Appendix D)

Self-locking nut (MS21044-N15) (3 required)

Self-locking nut (MS21044-N5 (2 required)

Lockwasher (MS35335-34) (4 required)

Lockwasher (MS45904-76)

PERSONNEL: Two

REFERENCES: TM 9-2350-222-10

PRELIMINARY PROCEDURES:

Remove powerplant (page 5-1)

Remove starter low voltage relay solenoid (page 10-33)

(2D engine only)

Go on to Sheet 2

TA139581

10-26