CLEANING AND INSPECTION

TM 9-2350-222-20-1-3

TRANSMISSION MOUNTS (LEFT AND RIGHT) REPLACEMENT (Sheet 3 of 4)

NOTE

It may be necessary to turn universal joint to gain access to screws (L).

Using 3/4 inch socket, remove three screws (L)

and lockwashers (M) from bracket (C). Throw

lockwashers away.

Remove bracket (C) from transmission.

10. Using hammer, remove spacer (N) from bracket

(C).

CLEANING AND INSPECTION:

Inspect bushing, mounts, and roller for

damages. If any parts are nicked, burred, or

out-of-round, replace damaged part.

INSTALLATION:

WARNING

Dry cleaning solvent P-D-680 is toxic

Position bracket (A) in vise and, using

and flammable. To avoid injury wear

remover tool, install two mounts (B) into

protective goggles and gloves and use

bracket (A).

in a well-ventilated area. Avoid contact

with skin, eyes, and clothes, and do not

Using 3-1/8 inch socket and T-slide handle,

breathe vapors. Do not use near open

install bushing (C) into bracket (A).

fire or excessive heat. The flash point

for Type I dry cleaning solvent is 100°F

(38°C), and for Type II is 140°F (60°C). If

you become dizzy while using dry

cleaning

solvent,

get

fresh

air

immediately and get medical aid. if

contact with eyes is made, wash your

eyes with water and get medical aid

immediately.

Clean all parts with dry cleaning solvent

and wipe dry with rags.

Go to Sheet 4

6-11

Change 4