TRANSMISSION MOUNTS (LEFT AND RIGHT) REPLACEMENT (Sheet 1 of 4)

TM 9-2350-222-20-1-3

TRANSMISSION MOUNTS (LEFT AND RIGHT) REPLACEMENT (Sheet 1 of 4)

PROCEDURE INDEX

PROCEDURE

PAGE

Removal

Cleaning and Inspection

Installation

TOOLS:

3-1/8 in, socket with 3/4 in. drive

T-slide handle with 3/4 in. drive

Diagonal cutting pliers

36 in. extension with 3/4 in. drive

Slip joint pliers

1-1 /2 in. open end wrench

1-1/2 in. socket with 3/4 in. drive

Ratchet with 3/4 in. drive

3/4 in. socket with 1/2 in. drive

Ratchet with 1/2 in. drive

1-5/16 in. open end wrench

Bench vise

Torque wrench with 3/4 in. drive (0-600 lb-ft) (0-813 N°m)

Bit screwdriver with 1/2 in. drive

Torque wrench with 1/2 in. drive (0-175 lb-ft) (0-237 N°m)

Ball peen hammer

SPECIAL TOOLS: Remover tool (Item 34, Chapter 3, Section 1)

SUPPLIES: Dry cleaning solvent (Item 54, Appendix D)

Goggles (Item 74, Appendix D)

Rubber gloves (Item 73, Appendix D)

Lockwire (Item 59, Appendix D)

Rags (Item 65, Appendix D)

Self-locking nut

Lockwasher

Lockwasher(3 required)

PERSONNEL: TWO

PRELIMINARY PROCEDURE:

Remove powerplant (page 5-1)

NOTE

The procedure applies to both right and left transmission

mounts.

Go on to Sheet 2

6-9

Change 4