 |
|||
|
|
|||
|
Page Title:
ENGINE FUEL LEAK CHECK-continued |
|
||
| ||||||||||
|
|
  TM 9-2350-222-20-1-3
2D ENGINE POWERPLANT TESTS (GROUND HOP) (Sheet 14 of 15)
WARNING
Fuel is delivered under high pressure from fuel pump to
injector nozzles. Injury to personnel could result if contacted
by spray from loose or defective fuel line.
CAUTION
DO NOT run engine for more than 10 minutes and do not
exceed 700-750 rpm.
8.
Start engine and run engine at idle speed (700-750 rpm) (TM 9-2350-222-10).
9.
Wearing goggles, check for leakage at all fuel line connections.
10. If leak is observed, shut down engine (TM 9-2350-222-10) and tighten or replace bad fuel line or
fittings.
11. When no leaks are observed, shut down engine (TM 9-2350-222-10).
12. Using 1-1/4 inch socket, remove cooling fan nut,
13. Remove fan rotor hub spacers from fan drive shafts.
14. Install cooling fans (page 9-49).
15. Install left bank engine access covers (page 6-93)..
16. Install right bank engine access covers (page 6-84).
17. Install engine shroud (page 9-3).
Go on to Sheet 15
5-61
Change 4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals