INSTALLATION-continued

TM9-2350-222-20-1-3

WARNING

The following summary list is adapted from the warnings within

this volume. However, all warnings should be observed as noted in

the text.

Support brake access covers with hand to prevent personal injury when removing covers.

Careless handling may result in serious injury to

Powerplant weighs more than 8500 pounds.

personnel or damage to equipment. Do not permit powerplant to strike hull.

Compressed air used for cleaning purposes will not exceed 30 psi. Use only with effective chip guarding

and personal protective equipment (goggles/shield, gloves, etc.).

Do not allow smoking, open flames, and tank or other vehicle operation within 50 feet while draining

fuel tanks.

Do not let upper and lower fuel-water sensor probes come into direct contact with each other or with

metal container during operational tests. Do not touch bare ends of sensor probe cables.

Assign one person with a fire extinguisher as fire guard during all powerplant tests.

Take all necessary safety precautions to eliminate possible injury to personnel or damage to equipment.

Stand clear of transmission output flanges whenever engine is running. Hearing protection is required.

During engine fuel leak check, observe for fuel leakage from a safe distance. Fuel is delivered under

high pressure from fuel pump to fuel injector nozzles. Injury to personnel could result if contact

spray from loose or defective fuel lines.

Ignition coils on engine are capable of producing extremely high voltage. Output of the ignition system

is sufficient to cause a dangerous electrical shock. Never touch any uncovered or live connections.

Transmission shroud is hot after operation. Allow engine to cool 1 hour before removing shroud. Wear

asbestos gloves for protection.